automatic feeding packing system line equipment maintenance

1. For your safety, please add a protective ground wire;
2. The inside and outside of the machine must be cleaned before and after work, and parts with food passing through must be strictly disinfected.
3. Please check whether the oil level of the gas source triplet oil storage tank is kept above 1/3 before going on and off work every day.If it is less than 1/3, you should inject 20# pure engine oil to about 1/2 of the tank body.
4. The unused packaging film should be taken out after work to avoid bending the support tube.
5. Frequently check the screws of each part, and there must be no looseness;
6. Keep the photoelectric head clean at all times, and the electrical parts should be dust-proof and moisture-proof;
7. If materials are found in the vertical seal or horizontal seal during the start-up process, the machine must be shut down and the vertical seal or horizontal seal shall be cleaned with a copper wire brush.
Causes and troubleshooting of common failures in automated packaging production lines：

automatic feeding packing system